Contact Us

SKU: SI-0565
Universal Microtube Holder

SKU: EPP0008
The on/off Timer Switch is easily installed by attaching to the front of the unit with a nut and re-attaching the two wires.

SKU: 566-0028-00
The Spring, Extension, Eccentric can be easily attached from the Eccentric Clamp to the Bottom of the Motor Mounting Plate.

SKU: SPP0001
To remove the old spring you may need to bend the tab that the spring is hooked onto and then replace with the new spring.

SKU: 0K-P236-904
This kit contains the Eccentric with Clamp Assembly, which includes the Eccentric, Bearing Retainer, Eccentric Clamp and Encoder Disc. This assembly is used on the Vortex-Genie Pulse Motor Assembly.

SKU: 0A-D236-010
This kit contains the Stainless Steel Mounting Bracket and Spring that attaches with adhesive strips onto the back of the Disruptor Genie and Digital Disruptor Genie casting.

SKU: 0A-D246-021
The 230V Motor Assembly for the Disruptor Genie can be easily installed using a 1/4” nut driver and then re-attaching the wires.

SKU: 0A-D236-021
The 120V Motor Assembly for the Disruptor Genie can be easily installed using a 1/4” nut driver and then re-attaching the wires.

SKU: 0A-D286-021
The 100V Motor Assembly for the Disruptor Genie can be easily installed using a 1/4” nut driver and then re-attaching the wires.

SKU: 0M-D236-400
Knob is easily installed by pushing onto the timer shaft.

SKU: EL-DD36-575
The Digital keypad is used on the 120V, 230V and 100V Digital Disruptor Genie. Thread the cable through the slot in casting. Peel and Stick Adhesive back adheres keypad easily to casting. Then connect the ribbon cable.

SKU: EB-DD36-500
The Digital Timer Board is used on the 120V, 230V and 100V Digital Disruptor Genie, and can be easily installed. Attaches with four mounting screws from inside of the unit.