Contact Us

SKU: 0K-1200-914
This is the large transformer on the back of the Enviro-Genie. It is easily installed, simply reconnect wires.

SKU: 0K-1200-904
This kit contains five Thermo Electric Coolers that are prewired in series for the Enviro-Genie. Kit also contains a small amount of Thermo Grease. Comes with instructions for installation.

SKU: ESP0007
This is the Power Switch for the 230V Enviro-Genie and Incubator-Genie.

SKU: ESP0006
This is the Power Switch for the 100V and 120V Enviro-Genie and Incubator-Genie.

SKU: 0K-1200-909
Smaller Gear with Pin used for Rocking Mode.

SKU: 0K-1200-916
This is the socket on the side of the Enviro-Genie and cable that connects to the LCD Display Board.

SKU: 0A-1100-030
This assembly contains the magnetic platform, which is used to rotate or rock samples when used with the appropriate magnetic accessories. The magnetic platform measures 200 x 340mm (8 x 14in) and is included with the Roto-Shake Genie, Enviro-Genie and Incubator-Genie.Print this Page

SKU: 0K-1200-922
This Power Distribution Board is used on all voltages of the Enviro-Genie. If your Enviro-Genie has LED's you will need to order Part No. 0K-1200-921.

SKU: 0K-1200-911
Complete Motor Assembly, with gears and drive shaft. This Motor Assembly is used on all voltages of the Enviro-Genie.

SKU: 0M-1200-214
Knob on the right of the unit, used to secure the Magnetic Platform Assembly for the Enviro-Genie and Incubator-Genie.

SKU: 0K-1200-913
Line Filter Kit is for conducted emissions for the Enviro-Genie.

SKU: 0K-1200-924
This is the LCD Display Keypad that attaches to the front panel of the Enviro-Genie. Thread the cable through the slot in sheet metal. Peel and Stick Adhesive back adheres keypad easily to sheet metal. Then connect the ribbon cable. If your Enviro-Genie has LED's you will need to order Part No. 0K-1200-901.