Contact Us

SKU: KBP0001
This Speed Control Knob was used in Vortex-Genie 2 mixers that were produced prior to the year 2000. It contains a set screw for attaching to the Rheostats and has a silver cap. This knob is used on the 120V, 230V and 100V Rheostats only.

SKU: 0M-0236-209
The Push-on Knob can be easily installed by pulling off the old knob and pushing on the new knob.

SKU: ESP0003
The Micro Switch can be easily installed using a philips head screw driver. This Micro Switch was used in the Vortex-Genie 2 mixers that were produced before the year 1998. If your Vortex-Genie 2 mixer has a brass thumb screw sticking out of the bottom of the unit, then you will use this Micro Switch. Please note, this switch has three tabs. If your Micro Switch has two tabs you will need to order Part No. ESP0005.

SKU: 0K-0286-915
The 100V Motor Assembly can be easily installed using a 1/4" nut driver and then re-attaching the wires. Please note, if your current motor is stamped Jakel Motors and there is a silver plate attached to the line cord in the housing, this motor has been discontinued. Jakel Motor Company has gone out of business. Unfortunately, our current motor will not fit in your Vortex-Genie 2 mixer.

SKU: 0K-0236-905
The 120V Motor Assembly can be easily installed using a 1/4" nut driver and then re-attaching the wires. Please note, if your current motor is stamped Jakel Motors and there is a silver plate attached to the line cord in the housing, this motor has been discontinued. Jakel Motor Company has gone out of business. Unfortunately, our current motor will not fit in your Vortex-Genie 2 mixer.

SKU: 0K-0246-915
The 230V Motor Assembly can be easily installed using a 1/4" nut driver and then re-attaching the wires. Please note, if your current motor is stamped Jakel Motors and there is a silver plate attached to the line cord in the housing, this motor has been discontinued. Jakel Motor Company has gone out of business. Unfortunately, our current motor will not fit in your Vortex-Genie 2 mixer.

SKU: 146-3011-00
Pop-off Cup

SKU: 0A-0286-050
This Rheostat was used in Vortex-Genie 2 mixers that were produced prior to the year 2000.

SKU: 0A-0236-050
This Rheostat was used in Vortex-Genie 2 mixers that were produced prior to the year 2000.

SKU: 0A-0236-051
This Rheostat was used in Vortex-Genie 2 mixers that were produced starting in the year 2000. The part in your unit should look the same as the picture, otherwise refer to Part No. EPP0005.

SKU: 0A-0246-050
This Rheostat was used in Vortex-Genie 2 mixers that were produced prior to the year 2000.

SKU: EB-0286-500
This 100V Speed Control was used on Vortex-Genie 2 mixers produced after the year 2000. It can be easily installed. The part in your unit should look the same as the picture, otherwise refer to Part No. 0A-0286-051.